The pattern notebook · nymph
Blowtorch Tag Nymph
How do you tie a Blowtorch Tag Nymph?
Blowtorch Tag Nymph is a nymph fly pattern for trout. Find its 9 materials and 8 tying steps below.
- Difficulty
- 3 of 5
- Target species
- trout
- Pattern designer
- Devin Olsen
Added to catalog · Updated
At the vise
Materials
- Jig Hook #12-16
- Tungsten Bead, 2.8-3.8mm
- Lead Wire - .015"
- Thread (6/0)
- CDC Feather - Natural
- Mirage Flashabou Wire, Small
- Tippet, 5X
- Ice Dub - Peacock Black
- Glo Brite Floss Fl. Fire Orange Or Fl. Orange. Three To Four Strands
Have some of these already? The app matches recipes against your inventory and helps you build a shopping list for the gaps.
Tying instructions
1. Slide the bead up to the eye and make four turns of .015" lead wire behind it. Break off the ends and shove the wraps tight against the bead. Start the thread behind the lead wraps and build a small thread dam from the bare shank up to the diameter of the lead, then continue making a thread base all the way back to the bend. Return the thread to just behind the bead.
2. Tie in three strands of Glo-Brite Floss just behind the bead and wrap over them to the bend, taking care to keep them on top of the hook. Return the thread to the starting point.
3. Tie in a single strand of Mirage Flashabou on the near side of the hook and wrap over it to the bend. Return the thread to the starting point and tie in a piece of 5X tippet material on the far side of the hook. Wrap over the tippet all the way back to the base of the tail.
4. Use the black peacock Ice Dub to build a tapered body from the base of the tail to just short of the back of the bead. Wrap the Flashabou rib forward over the body and tie off, then counter-wrap the tippet material forward over the flash for durability. Tie off the tippet material and trim it along with the Flashabou.
5. Select a CDC feather with a thin stem. Strip the inside of the feather—if you tie right-handed, you will strip the left side of the feather. I also like to “thumbnail” the remaining fibers to length ahead of time, so they are broken off to about the same length as the hook shank.
6. Tie in the CDC feather by its tip, then fold the tip to the rear and make a couple of thread wraps over it to secure it. Clip the excess.
7. Make no more than two turns of CDC just behind the bead and tie it off. Clip the excess and build a smooth thread collar while sweeping the fibers back slightly. Whip-finish the thread but do not clip it.
8. Coat the working thread with a smear of clear Solarez Bone Dry. Do this right up close to the hook. Wrap the wet thread over the thread collar, using the thread as the applicator to place the resin precisely on the thread collar without bleeding into the base of the CDC collar. Make three or four turns of thread to apply the resin, then unwrap and clip the thread before curing the resin with your UV lamp. Finally, clip the Glo-Brite Floss even with the outside of the hook bend, leaving a short stubby hot spot tag.